Plastic drop wire clamp ACC FTTH optical fiber clamp designed to anchor round FTTH drop cable in FTTX or fiber optic to home construction . Plastic drop wire clamp ACC can be used on dead-end or double dead-end fiber network routes with aerial fiber optic cable. FTTH drop cable accessory is very easy for installation. Can be applied for cable diameters 2 to 6mm.
FTTH/PON optical fiber clamp designed to anchor routes round cable in FTTX construction. Drop clamp ACC cable clamp can be used on dead-end or double dead-end fiber network routes.
Share:
The plastic drop wire clamp ACC or round cable drop clamp is designed to anchor round fiber cables on dead-end lines. Usually use for FTTH. It is made out of high strength and toughness.It is made out of UV resistant nylon for a life span guarantee of min 25 years.
How to install the plastic drop wire clamp ACC？
The cable span end is introduced in the clamp at point A. The cable roll up is carried out around the mandrel clockwise until the full width of the mandrel is covered (3 full turns in case of a Ø 4mm drop cable). The drop cable exits the clamp through B. The cable section after that point is free of any load and can be connected to the wall distribution box or installed in the next drop clamp in case of double dead-ending.
Adjusting the load on the span side is easily achieved by simultaneously pulling by hand the cable at A and B following the arrows.
Characteristics
Characteristics plastic drop wire clamp ACC：
Anti-drop wire bail design.
Tools free, easy installation and removable.
Full dielectric UV resistant thermoplastic, durable.
Excellent environmental stability.
Specification
Specification Plastic drop wire clamp:
Product name:Plastic drop wire clamp ACC
Application: it is suitable roundcable 2-6mm
Span:30-70 m
Material:UV resistant plastic
Breaking load,KN:1
Inquiry
You Might Also Like
